Hand Held Products 4410 - Manual (Page 35)

IMAGETEAM™ 4410/4710 User’s Guide 2 - 15
Note: ‡ A one to three digit decimal number and
Save are required after reading this programming symbol. See "Decimal
to Hex to ASCII Conversion Chart" on page 2-36, and the Programming
Chart (inside back cover).
Trigger Timeout
Use this selection to set a timeout (in quarter seconds) of the Imager’s trigger.
Once the imager has timed out, it must be triggered again either serially (see
"Serial Triggering" on page 2-14), or manually. Set the Trigger Timeout to 00 if
you don’t want a Trigger Timeout.
Default setting = 120 seconds
Set Timeout ‡