Hand Held Products 4410 - Manual (Page 39)

IMAGETEAM™ 4410/4710 User’s Guide 2 - 19
Aimer Interval
Aimer Interval turns off the aiming light, or programs the aimer to come on at
certain intervals when reading symbols with the scanner. You may program the
scanner to use the aimer
Every Read, Every Second Read, or Every Third
Read. You may also program the scanner to use the aimer every “x” reads, by
entering a number from 0 to 999 to indicate “x.”
Note: ‡ A one- to three digit number and Save are
required after reading this programming symbol. Refer to the
Programming Chart (inside back cover).
* Every Read Off
Every “x” Reads ‡
Every Second Read Every Third Read