Hand Held Products 4410 - Manual (Page 50)

2 - 30 IMAGETEAM™ 4410/4710 User’s Guide
Intermessage Delay
Note: This selection is valid for keyboard wedge interfaces only.
This is a delay of up to 495 milliseconds (in multiples of 5) placed between each
scan transmission. You can program up to 99 steps (of 5 ms each). Scan the
Intermessage Delay bar code below, then scan the number of steps, and the
Save bar code from the inside back cover.
Note: If you make an error while scanning the digits (before scanning Save),
scan Discard on the back cover and scan the correct digits and Save
again.
To remove this delay, scan the Intermessage Delay bar code, then set the
number of steps to 00. Scan the Save bar code from the inside back cover.
2nd Scan Transmission 1st Scan Transmission
Intermessage Delay
Intermessage Delay