Hand Held Products 4410 - Manual (Page 47)

IMAGETEAM™ 4410/4710 User’s Guide 2 - 27
Power Up Beeper
Output Sequence Beeper
If you are using an Output Sequence (see "Output Sequence Overview" on page
2-43), you may want to hear a beep after each bar code as it is read. Scan
Output Sequence Beeper
On to enable this feature, or Off to disable it.
Beep On Decode
If you want the scanner to beep each time it reads a bar code, leave this setting
On. If you don’t want it to beep on each read, but do want it to beep for other
events, such as error conditions, set this selection to
Off.
Beeper Default
Defaults all beeper settings. Defaults = Beeper Volume High, Power Up Beeper
On, Output Sequence Beeper On, Beep On Read On.
* On Off
* On Off
* On Off
Beeper Default