Hand Held Products 4410 - Manual (Page 118)

4 - 6 IMAGETEAM™ 4410/4710 User’s Guide
Note: Note: If using Quick*View to program, use the
space bar to designate a space and not the hex value of 20.
5. Exit OCR Template Editor
Scan Save OCR Template to save your entries. Discard OCR Template
exits without saving any OCR Template changes.
Stringing Together Multiple Formats
(Creating “Or” Statements)
You may want to program the scanner to accept many OCR formats. To do this,
you would string together each format with a “t.” This tells the scanner to read
optical characters that match any one of the formats in the template.
Example D: You need to read any combination of 8 digits, or a combination
of 4 digits, 2 uppercase letters, and 2 digits. The template would be:
ddddddddtddddlldd
To create this template, you would scan the Enter OCR Template symbol
(page 4-9), scan the d from the OCR Programming Chart after the Sample
Codes in the back of this manual 8 times, then scan the t to create the “or”
statement. Then you would scan the characters for the 2nd template. Scan
the
d 4 times, scan l 2 times, then scan d 2 more times. Scan Save OCR
Template (page 4-9). This would let you read either type of format, for
example:
99028650
or
9902XZ50
You can string together as many templates as you need.
Creating a User-Defined Variable
You can create up to two of your own user variables for an OCR template. These
variables will represent any OCR readable characters. The user-defined
variables are stored under the letters “g” and “h.” Creating a user variable follows
the same steps as creating a template, but instead of scanning the
Enter OCR
Template symbol, you scan the Enter User-Defined Variable symbol (page 4-
9). The letters g and h can then be used in an OCR template to define the
variable you specified.