Hand Held Products 4410 - Manual (Page 185)

IMAGETEAM™ 4410/4710 User’s Guide 11 - 3
To Replace the IT4710 Interface Cable:
1. Turn the power to the host system OFF.
2. Disconnect the Imager’s cable from the terminal or computer.
3. Insert a small, flat head screwdriver into the slot between the cable and the
back end of the housing.
4. Press the screwdriver tip down to
depress the retention tab,
releasing the connector.
5. Pull the connector out of the
Imager while maintaining
pressure on the screwdriver.
6. Replace with the new cable.
Insert the connector into the
opening at the base of the Imager. Press firmly. The connector is “keyed” to
go in only one way, and will click into place.
Troubleshooting
The Imager automatically performs self-tests whenever you turn it on. If your
Imager is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Troubleshooting Guide
Is the power on? Are the illumination LEDs on?
If the illumination LEDs in the Imager aren’t illuminated, check that:
1. The cable is connected properly.
2. The host system power is on (if external power isn’t used).
Is the Imager having trouble reading your symbols?
If the Imager isn’t reading symbols well, check that the symbols:
1. Aren’t smeared, rough, scratched, or exhibiting voids.
2. Aren’t coated with frost or water droplets on the surface.
3. Are enabled in the Imager or in the decoder the Imager connects to.
Cable
Release