Hand Held Products 4410 - Manual (Page 84)

3 - 14 IMAGETEAM™ 4410/4710 User’s Guide
Linear Symbologies
Code 93
< Default All Code 93 Settings >
Code 93
Message Length
The message length selection is used to set the valid reading length of the bar code.
If the data length of the scanned bar code doesn’t match the valid reading length, the
scanner will not read the symbol. You may wish to set the same value for minimum
and maximum length to force the scanner to read fixed length bar code data. This
helps reduce the chances of a misread.
EXAMPLE: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09 Max. length = 20
EXAMPLE: Decode only those bar codes with a count of 15 characters.
Min. length = 15 Max. length = 15
The desired message length and Save must be input after reading this
programming symbol. Refer to the Programming Chart (inside back cover).
On * Off
Maximum
Message Length
Minimum
Message Length