Honeywell VOYAGER 1200G - Manual (Page 131)

6 - 37
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an
addenda is not found within this time period, the data can be either trans-
mitted or discarded, based on the setting you are using for
UPC-A
Addenda Required (see page 6-36). Set the length (in milliseconds) for this
timeout by scanning the bar code below, then setting the timeout (from 0-
65535 milliseconds) by scanning digits from the
Programming Chart , then
scanning Save . Default = 100.
Note: The Addenda Timeout setting is applied to all addenda and coupon
code searches.
UPC-A Addenda Separator
When this feature is on, there is a space between the data from the bar
code and the data from the addenda. When turned off, there is no space.
Default = Off.
UPC-A Redundancy
If you are encountering errors when reading UPC-A bar codes, you may
want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the
number of errors. Note that the higher the redundancy count, the longer it
will take to decode the bar code. To adjust the redundancy, scan the UPC-
A Redundancy bar code below, then scan a redundancy count between 0
and 10 on the
Programming Chart inside the back cover of this manual.
Then scan the Save bar code. Default = 0.
Addenda Timeout
* Off
On
UPC-A Redundancy