Honeywell VOYAGER 1200G - Manual (Page 62)

3 - 12
End Object Detection After Good Read
After a bar code is successfully detected and read from the scanner, the
laser can be programmed either to remain on and scanning, or to turn off.
When End Object Detection After Good Read is enabled, the laser turns
off and stops scanning after a good read. If you scan Do Not End Object
Detection After Good Read, the laser remains on after a good read.
Default = End Object Detection After Good Read.
Object Detection Laser Timeout
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes after an object is detected. Set the length
(in milliseconds) for a timeout by scanning the bar code below, then setting
the timeout (from 1-65535 milliseconds) by scanning digits from the
Programming Chart , then scanning Save . Default = 5000 ms.
* End Object Detection After
Good Read In-Stand
Do Not End Object Detection
After Good Read In-Stand
* End Object Detection After
Good Read Out-of-Stand
Do Not End Object Detection
After Good Read Out-of-Stand
Object Detection Laser
Timeout In-Stand
Object Detection Laser
Timeout Out-of-Stand