Honeywell VOYAGER 1200G - Manual (Page 136)

6 - 42
UPC-E0 Number System
The numeric system digit of a UPC-A symbol is normally transmitted at the
beginning of scanned data. When using UPC-E Expand, the unit can be
programmed so it will not transmit it.
Default = On.
UPC-E0 Number System and Check Digit
UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at
the end of the scanned data or not.
Default = Off.
Off
* On
Check
Digit Number
System
UPC-E0 sample showing the number system and check digit:
* Off
On