Honeywell VOYAGER 1200G - Manual (Page 29)

2 - 7
ACK/NAK Mode
Communication Timeout
This allows you to set the length (in milliseconds) for a timeout for the host
ACK/NAK response. Scan the bar code below, then set the timeout (from
0-65535 milliseconds) by scanning digits from the
Programming Chart ,
then scanning Save . Default = 2000 ms.
Timeout Retries
This setting limits the number of Communication Timeout retries. If the
Timeout Retries is set to 0, the transmission is terminated after the ini-
tial Communication Timeout. Scan the bar code below, then set the
number of retries (from 0-255) by scanning digits from the
Programming Chart , then scanning Save . (5 is the recommended set-
ting.) Default = 0.
ACK/NAK Mode On
* ACK/NAK Mode Off
Communication Timeout
Timeout Retries