I. specifi cations a. specifi cation sheet – Hoshizaki JWE-620UA-6B User Manual

Page 6

Advertising
background image

1

I. Specifi cations

A. Specifi cation Sheet

WASH TANK SIDE

BOOSTER TANK SIDE

3 phase 3-wire 208-230V/60Hz (±10%)
15.8kVA(39.7A)
Max Running 36.6A, Rated Motor 4.2A
26.0A
Rated Motor 1.40kW (Power Factor 85%)
Max 14.30kW

AC SUPPLY VOLTAGE
POWER SUPPLY CAPACITY
AMPERAGE
STARTING AMPERAGE
ELECTRICAL CONSUMPTION

HEATER

6.9kW

6.0kW

RACK SIZE

NUMBER OF LARGE DISHES / RACK

CYCLE TIME
WATER CONSUMPTION

19-3/4" Ч 19-3/4"(500 Ч 500mm)
16 plates (9.1” DIA)
53 sec (wash 41 sec, dwell 5 sec, rinse 6 sec, dwell 1 sec)
0.53Gal/cycle(2.0L/cycle)

OUTSIDE DIMENSIONS
EXTERIOR
DOOR

W25.2" × D25.8" × H60.5" (W640 × D655 × H1,537mm)
Stainless Steel
Vertical Sliding Door (opening height 18.0") (457mm)
Upper and Lower Triple Spray Arms (common arms on top and bottom)
Upper and Lower Wide Angle Spray Arms
Wash 1HP, Rinse 0.134HP
Draw Out Overflow Pipe, Overflow Drain
Door Switch (start switch mode also available)
Residual Heat Drying
Filter Collection
Not Provided
Ready, Auto Fill, Rinse, Wash-Standard, Wash-Long, Pause
Wash Water Temperature, Rinse Water Temperature, Error
14.3Gal (54L)
Automatic Hot Water Supply by
Microprocessor Control
Wash: 150ºF(66ºC) min.

Thermistor Control: 163ºF(73ºF) -
168(76ºF)

1.9Gal (7.3L)
Automatic Hot Water Supply by
Water Valve
Rinse: 180ºF(82ºC) min.

Thermistor Control: 182ºF(83ºC)-185ºF (85ºC)

WASH SYSTEM
RINSE SYSTEM
PUMP
DRAIN SYSTEM
START
DRY SYSTEM
REFUSE DISPOSAL
DETERGENT
DISPLAY

TANK CAPACITY
HOT WATER SUPPLY

TEMPERATURE CONTROL

CONNECTION – WATER SUPPLY
– DRAIN

Inlet: 3/4"FPT
Outlet: 1-1/2"MPT

WASH TIME

Standard: 1 - 99 sec, in 1 sec steps
Long: 10 - 990 sec, in 10 sec steps Microprocessor control

CONTROL

RINSE TIME
END BUZZER VOLUME

5 - 12 sec, Adjustable, in 1 sec steps
0 - Max, Adjustable
Ground Fault Circuit Interrupter (with Overcurrent Protector)
Water Level Switch,
Bimetal Thermostat (Manual - Reset),
Thermistor (Auto - Reset)

Float Switch,
Bimetal Thermostat (Manual - Reset),
Thermistor (Auto - Reset)

ELECTRIC CIRCUIT PROTECTION
BOIL – DRY PROTECTION

SAFETY SYSTEM

Door Switch, Emergency Stop by Microprocessor Control

WEIGHT

Net 247lb (112kg) / Gross 344lb (156kg)

PACKAGE

Carton + Crate
W32.1"×D34.6"×H68.0" (815mm × 880mm × 1,726mm)

CERTIFICATION

NSF ANSI-3, ETL, Energy Star

ACCESSORIES

Universal rack (19-3/4" x 19-3/4") x 1, Instruction manual x 1
Installation manual x 1, Maintenance sheet (English and Spanish)x 1
Inlet water strainer & Packing x 1,

OPERATION CONDITIONS

Ambient Temperature: 41 - 95ºF (5ºC - 35ºC)
Voltage Range: Rated Voltage ±10%
Recommends Water Hardness : 4gpg (grains per gallon) (68.5ppm) or less
Water Supply Temperature: 110 - 167ºF (43ºC - 75ºC) ( Recommends 140 ºF (60ºC))
Water Supply Pressure (Gauge Static Pressure): 10 - 70PSIG (0.07 - 0.48 MPa)

* The rated properties are based on measurements at ambient temperature of 86ºF (30ºC) according to the Technical

Requirements for Electrical Appliances.

* We reserve the right to make changes in specifications and design without prior to notice.

Advertising