HP QMS 1660E User Manual
Page 176
Advertising
Optional
Interfaces
QMS 1660E Print System Reference
6-42
4
Attach the interface.
a
Position the interface so the port slides into the opening you
just created.
b
Snap the plastic standoff onto the controller board.
c
Snap the interface onto the 80-pin connector and the plastic
standoff, both on the controller board.
It’s okay to push down gently with your thumb positioned on
the interface right over the connector.
5
Secure the interface to the printer with the screws you re-
moved earlier.
6
Replace the controller board and printer covers.
Use the instructions in the “Replacing the Printer and Controller
Board Covers” section of this chapter.
7
Reconnect all interface cables and the power cord, and then
turn on the printer.
80-pin
Connector
Standoff
Advertising