HP QMS 1660E - Manual (Page 259)

Updated DOC
Commands
C-13 Document Option Commands
Resource Command
Syntax %%IncludeFeature:resource (resource id object code)
Purpose Establishes the current resource and the default object code
value for the current job to which it is attached.
Notes This command is identical to the %%IncludeFeature:install
DOC command. It is included for backward compatibility.
All downloaded objects are by default temporary, and will be
deleted at the end of a job unless Retain Temporary is set to on,
true, or on compatibility. If the file that the %%IncludeFeature:
resource command is attached to does not make the
downloaded font permanent and Retain Temporary is not set,
then those objects are removed from the disk when the job
completes.
A downloaded font can only be accessed by its ID if the font is
stored in the current resource. Regardless of its resource, a font
can be selected by its attributes.
Variables resource id
Purpose Identifies one of the possible locations for
downloaded objects.
Range 0-6
Default Internal system disk
(usually DSK6:/BIN/EMULATE/PCL/FONTS
Format Integer
Notes If no resource item is provided, the internal default
location is used; otherwise, this parameter, which
must be provided, specifies one of the alternate
locations. For most QMS printers, resource 6 is the
system disk.
object code
Purpose Assigns a code to an object such as a font, macro, or
pattern.
Range 0-32767
Range 0
Format Integer