HP QMS 1660E - Manual (Page 202)

Storage
Options
QMS 1660E Print System Reference 6-68
Using the Printer Configuration Menu
After you have accessed the Administration/Disk Operations menu,
press the control panel keys in the order shown in the following table.
The printer responds by displaying a status message in the message
window.
» Note: You may need to press the Next key one or more times to
advance through the list of selections or options.
» Note: After an unformatted disk is formatted and the FORMAT
COMPLETE message displays, you must turn the printer off and back
on again before the printer can recognize the disk.
Using a Hard Disk
Before you can use a formatted hard disk, you must increase the size
of the disk cache. The way you do this depends on how much mem-
ory your printer has.
n
If your printer has 12 MB of RAM, enable disk swapping
(Administration/Memory/Enable Disk Swap menu), which
Use this
key... to... The message window
reads...
Select Access the Administration/Disk
Operations/Format Disk menu. DISK OPERATIONS
FORMAT DISK
Select Access the Format Disk/Dsk#: menu. FORMAT DISK
DSK#: x
Next Scroll through the list of attached disks. FORMAT DISK
DSK: x
Select Select the disk and display a format
confirmation message. FORMAT DISK
ARE YOU SURE?
Select Begin the formatting process. The hard
disk is formatted while the system
reboots. FORMAT DISK
FORMATTING...
You are informed when the formatting
process is complete. The printer then
reboots, and a start-up page prints (if
enabled). FORMAT DISK
FORMAT COMPLETE