Color to color calibration – HP 1055CMHP User Manual
Page 132
Service Calibrations
5-16
HP DesignJets 1050C and 1055CM Printers Service Manual
6. Color to Color calibration
The purpose of this Service Calibration is to correct the alignment
between the Printheads and the rest of the Printer. This calibration is
necessary in order to prevent color misalignment.
Perform the Color to Color Calibration whenever:
n
Carriage is disassembled or replaced.
n
Drive Roller is disassembled or replaced.
n
Problems with color misalignment.
n
Paper-Axis is disassembled or replaced.
n
Platen Assembly is disassembled or replaced.
n
Service Station is disassembled or replaced.
Perform the Color to Color Calibration as follows:
NOTE
Make sure that you load E/A0 size HP High Gloss Photo Paper
or HP Coated media before performing this calibration. Do NOT
use any other type of media apart from HP Coated or HP High
Gloss Photo Paper.
1 In the Service Calibrations submenu, scroll to "6. Color to Color
cal" and press Enter.
2
The following message will appear asking you to confirm the operation.
Select ACCEPT if you want to continue the Calibration, or select CANCEL
if you want to cancel the it. Press Enter once the selection has been made
.
Top
Enter
Back
↑
↓
Press Enter
Service Calibrations
4. Roller mark position...
5. Pen to Paper Spacing...
7. Calibrations Backup...
8. Pen alignment...
Make Selection
6. Color to Color cal...
6. Color to Color cal.
Cancel
Accept
Top
Enter
Back
↑
↓
Press Enter
Make Selection