HP 1055CMHP - Manual (Page 212)

Removal and Installation
8-4
HP DesignJets 1050C and 1055CM Printers Service Manual
Right Hand Cover
Refer to Figure 1
Removal
1. Remove the Printhead Cleaners (Refer to the User Guide).
NOTE Make sure that the Service Station Carriage is pushed to the
back before trying to remove the Right Cover.
WARNING Switch off the printer and remove the power cable.
1. Remove the following:
1. "Electronics Module Left Rear Cover" see page 8-24.
NOTE Make sure you take care when removing the ferrite which is
attached to the sideplate with a cable tie.
2. Disconnect the front panel cable from position P16 FRONT
PANEL on the electronics module.
3. Disconnect the aerosol fan cable from position P7 AEROSOL FAN
on the electronics module.
4. Remove two T-15 screws (item 1) from the right hand trim (item 2).
NOTE Be careful not to drop the cover (item 3) once the securing
fasteners have been removed. Support the cover throughout the
next step.
5. Remove two T-15 screws (item 4) from the rear of the right hand
cover which are securing the cover to the right hand side chassis.
6. Remove the right hand cover (item 3) by making sure you:
a carefully pull the front panel cable and the aerosol fan cable from
a hole in the right hand side chassis.
b disconnect the service station door sensor cable, which hangs
down from the service station cable.