Henny Penny OFE-321 - Manual (Page 10)

Model OFE-321,322
1-4. WARNINGS AND
ERROR MESSAGES
(Continued)
ERROR CODES
DISPLAY CAUSE CORRECTION
“E-4” PC board too hot Check ventilation louvers on side of fryer
“CPU TOO for obstructions; if louvers are clear,
HOT” have PC board checked
“E-5” Controls sensing 405°F Have heat components and temperature
“FRYER TOO or above probe checked
HOT”
“E-6” ( A or B ) Faulty temperature probe or Have temperature probe and connection
“FRYER connection checked
TEMP
SENSOR
FAILED”
“E-10” Shortening temperature too hot, Reset high limit (see Operating Components
“HIGH LIMIT drain valve opened while heat was Section); check shortening temperature for
TRIPPED” on, or faulty high limit overheating; have heat components checked
if high limit continues to trip.
“E-15” Drain is open or faulty microswitch Close drain; have drain microswitch
“DRAIN IS checked if error code persists
OPEN”
“E-25” Wrong or faulty elements or wiring Have electrical supply, wiring, and elements
“HEAT AMPS problem checked
WERE TOO
HIGH”
Because of the seriousness of this
error code, turn the POWER switch
off and back on to cancel
“E-26” Faulty contactors or PC board Have the contactors and PC board checked
“HEAT AMPS
ARE LOCKED
ON”
This error code could be displayed
even with the POWER switch turned
off. Unplug fryer or shut off the
wall circuit breaker to disconnect
electrical power to fryer.
1-6
405