Henny Penny OFE-321 - Manual (Page 6)

Model OFE-321,322
1-3. TROUBLESHOOTING To isolate a malfunction, proceed as follows:
1. Clearly define the problem, or symptom and when it
occurs.
2. Locate the problem in the troubleshooting table.
3. Review all possible causes, then one at a time, work
through the list of corrections until the problem is solved.
If maintenance procedures are not followed correctly,
injuries and/or property damage could result.
PROBLEM CAUSE CORRECTION
With the switch in
• Open circuit • Check to see if unit is plugged in
the POWER position,
fryer is completely
• Check breaker or fuse at supply box
inoperative
• Check POWER switch per Power Switch
Section; replace if defective
• Check voltage at wall receptacle
• Check cord and plug
Shortening will not
• Faulty contactor • Check contactor per Heating Contactors
heat but lights are on (elec. model) Section
• Faulty temperature • Check temperature probe per Temperature
probe Probe Replacement Section; “E-6A or B”
• Faulty high limit • Check high limit per the appropriate High
Temperature Limit Control Section; “E-10”
• Faulty drain switch • Check drain switch per Drain Microswitch
Section; “E-15"
1-2
405