Honeywell RAPID EYE K9696V2 - Manual (Page 19)

2–1
2 Field Work
Audience
Field technicians, tasked with the initial steps of an installation (see sections 1.2.1 and
1.2.2), will find the steps expanded and explained in more detail, in this section.
!13 Road map to field work
•
Unpack the unit.
•
As you start connecting hardware to the Multi-Media unit, use the Site
Information Checklist on p. 7–8, to take notes.
•
Connect one or more cameras to the unit.
•
According to the communications that you plan to use, connect the unit to: a
telephone line, your network or both.
•
Power up the camera(s) and the Multi-Media unit.
•
For network connections only, to assign a TCP/IP address to the Multi-Media
unit, use either:
(a) the LocalView interface (included) and a monitor (not included), or
(b) a PC (not included) and a null-modem cable (included).
•
Field-test the connection to the unit.
Please do not remove factory seals on a Multi-Media unit.
Breaking them voids your warranty. There are no user-serviceable parts inside.
Field technicians, tasked with the initial steps of an installation (see sections 1.2.1 and
1.2.2), will find the steps expanded and explained in more detail, in this section.
2.1 Unpacking the Unit
!14 To unpack a unit
1. Open the box and remove the Rapid Eye Multi-Media unit, the power cord and
other items from the box. The contents are listed in table 1.
2. Remove the plastic bag that surrounds the unit.
3. Store the box and packaging materials.