Honeywell RAPID EYE K9696V2 - Manual (Page 76)

Multi-Media Unit: Installation Instructions
7–2
!30 To upgrade a Multi-Media unit’s software, onsite 2–17
!31 Road map for using Multi software to obtain video 3–1
!32 To install Multi software 3–2
!33 To continue installing a Multi-Media unit ... 3–3
!34 To create an empty Multi db 3–4
!35 To name a site 3–5
!36 To make a record of a dial-up connection 3–6
!37 To make a record of a network connection 3–8
!38 To run a maintenance session on a Rapid Eye site 3–10
!39 To indicate the time zone of a Multi-Media unit 3–12
!40 To respond to a notification of conflicting time zones 3–13
!41 To set a unit’s clock automatically, using SNTP 3–13
!42 To set a unit’s clock manually, using a PC’s 3–14
!43 To configure a Rapid Eye site’s camera(s) 3–16
!44 To obtain video from a “live video session” 3–16
!45 To send and receive audio offsite 4–3
!46 To monitor and record 4–3
!47 To enable “talking to” a site 4–3
!48 To enable audio for use onsite, by LocalView 4–4
!49 To disable audio for LocalView 4–4
!50 To secure the unit 5–1
!51 To detach the sub-panel 5–2
!52 To connect an alarm sensor 5–6
!53 To configure inputs 5–6
!54 To set the FAULT RELAY to trigger 5–9
7.2 Tables
Table 1 contents of Rapid Eye’s hardware kit, WAMULTI5HWP4 2–2
Table 2 contents of Rapid Eye’s software kit, WAMULTI5SWP4 2–2
Table 3 Panel connectors 2–3
Table 4 Time needed for a Multi-Media unit recovery 2–6
Table 5 Restriction for LocalView cycle times when setting low recording rates 2–9
Table 6 Commands for launching HyperTerminal 2–13
Table 7 Settings for HyperTerminal communications session 2–13