If the light is flashing, If the light is on steady – Hummer 2006 H3 User Manual

Page 160

Advertising
background image

If the Light is Flashing

The following may prevent more serious damage to
your vehicle:

Reducing vehicle speed

Avoiding hard accelerations

Avoiding steep uphill grades

If you are towing a trailer, reduce the amount of
cargo being hauled as soon as it is possible

If the light stops flashing and remains on steady,
see “If the Light Is On Steady” following.

If the light continues to flash, when it is safe to do
so, stop the vehicle. Find a safe place to park your
vehicle. Turn the key off, wait at least 10 seconds and
restart the engine. If the light remains on steady, see
“If the Light Is On Steady” following. If the light is
still flashing, follow the previous steps, and see your
dealer for service as soon as possible.

If the Light Is On Steady

You may be able to correct the emission system
malfunction by considering the following:

Did you recently put fuel into your vehicle?

If so, reinstall the fuel cap, making sure to fully install
the cap. See Filling the Tank on page 5-8. The
diagnostic system can determine if the fuel cap has
been left off or improperly installed. A loose or missing
fuel cap will allow fuel to evaporate into the atmosphere.
A few driving trips with the cap properly installed
should turn the light off.

Did you just drive through a deep puddle of water?

If so, your electrical system may be wet. The condition
will usually be corrected when the electrical system
dries out. A few driving trips should turn the light off.

3-36

Advertising