Heat & Glo Fireplace 8000CF-OAK-IPI - Manual (Page 47)

Heat & Glo • 8000CF-OAK-IPI • 2059-900 Rev. R • 6/09 47
G. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• Place dime-size pieces of Glowing Embers® just in front
of the port trail, but not on or in between the ports (see
Figure 14.4). Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.
Figure 14.4 Placement of Embers
• Place Mystic Embers on areas of base refractory away
from port holes. Use this material to give the appliance
a realistic ash bed.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
F. Install the Optional Refractory
Install optional refractory following instructions in refractory
kit.
EMBER
MATERIAL
DO NOT
PLACE EMBER MATERIAL BETWEEN
BACK ROW OF BURNER PORTS AND BACK
EDGE OF BURNER. (EMBERS IN THIS
AREA WILL CAUSE SOOTING.)