Hand Held Products 4410 - Manual (Page 35)

2 - 15
Trigger Timeout
Use this selection to set a timeout (in quarter seconds) of the Imager’s trigger.
Once the imager has timed out, it must be triggered again either serially (see
"Serial Triggering" on page 2-14), or manually. Set the Trigger Timeout to 00 if
you don’t want a Trigger Timeout.
Default setting = 120 seconds
‡ A one- to three digit number and Save are required after reading this
programming symbol. Refer to the Programming Chart (inside back
cover).
Set Timeout ‡