Hand Held Products 4410 - Manual (Page 93)

3 - 23
Linear Symbologies
UPC E0
< Default All UPC E0 Settings >
UPC E0
Most UPC bar codes lead with the 0 number system. For these codes, use the
UPC E0 selection. If you need to read codes that lead with the 1 number system,
use the UPC E1 selection (see "UPC E1" on page 3-24).
Check Digit
This selection allows you to specify whether the check digit should be
transmitted at the end of the scanned data or not.
Number System
The numeric system digit of a UPC symbol is normally transmitted, but the unit
can be programmed so it will not transmit it.
UPC E0
On
* UPC E0
Off
Transmit
Check Digit
* Don’t Transmit
Check Digit
* Don’t Transmit
Number System Transmit
Number System