Hand Held Products 4410 - Manual (Page 44)

2 - 24
AutoTrigger
Two AutoTrigger Modes are available: Scan Stand and Presentation Mode.
When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan
Stand symbol. (See Scan Stand Symbol that follows.) When a different code is
presented, the Imager is triggered to read the new code.
Note: The scanner automatically adjusts the illumination LEDs to the lowest light
level possible to maintain a good lock on the Scan Stand symbol.
Presentation mode is for those applications where a scan stand will not work, i.e.,
when large packages must be scanned. To program the device for presentation
mode, refer to "Presentation Mode" on page 2-25.
Scan Stand
This selection programs the Imager to work in a Scan Stand.
Scan Stand Symbol
When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand symbol
on the base of the stand which tells it to remain idle.
When the Scan Stand
symbol is covered, the imager turns the LEDs on at the configured power level
(Default High) and attempts to find and decode bar codes in its field of view.
On * Off
Scan Stand
Symbol