Humax L3040 - Manual (Page 15)

15
Connecting a PC ( DVI )
1. Connect a DVI 29pin cable(not supplied) to the DIGITAL PC INPUT jack on the LCD TV and DVI
output jack on the PC.
2. Connect audio cables(not supplied) to the AUDIO INPUT jacks on the LCD TV and audio output
jack on the PC.
NOTE : When you connect a DVI, Please note the Analog input is not supported.
To watch the PC screen :
1. Turn on LCD TV and press the SOURCE button to select the DVI.
2. Turn on PC and check for PC system requirements. Refer to the
‘Operation with a PC’ section.
3. Adjust the PC screen.
Setting up Your LCD TV Plug and Play
Our adoption of the new VESA ® Plug and Play solution eliminates complicated and time consuming setup.
It allows you to install your LCD TV in a Plug and Play compatible system without the usual hassles and
confusion. Your PC system can easily identify and configure itself for use with your display. This LCD TV
automatically tells the PC system its Extended Display Identification Data(EDID) using Display Data
Channel(DDC) protocols so the PC system can automatically configure itself to use the flat panel display.
Connection
Rear of the LCD TV
DVI-I 29pin Cable
Audio Cable
PC