Humax L3040 - Manual (Page 54)

54
Serial Control Using RS-232C
Using the Hyper terminal
At the connected Hyperterminal Window:
File Preference Setup ASCII Setup dialog window
1. Check the two items in the ASCII Sending section.
2. Check the first and third items in the ASCII receiving
section.
You have completed the preparations to communicate with the LCD TV using your PC. If
you enter the following commands in Hyperterminal, the LCD TV will execute your
commands.
Using the Hyper Terminal
Hyperterminal is an application for serial
communications. It is offered as part of the basic
MS Windows operating system.
After executing Hyperterminal, set up as
follows.
[COM1 Property dialog window]
Bits/sec : 9600 bps
Data Bits : 8 bits
Parity Bits : None
Stop Bits : 1 bit
Flow Control : None