HP 2605dtn User Manual
Page 108
2.
Use the following procedure to configure the printer to Print on both sides (manually).
In the printer driver, select the Finishing tab, select the Print on both sides (manually) option,
and then send the job to print.
3.
After the job is finished printing, remove any blank paper as prompted by the control panel. Lift
the printed stack from the output bin and insert the printed stack without rotating or turning the
stack over into the printer tray that was used for the first part of the job.
A
4.
Press (
Select
) to continue printing on the second side.
To print on both sides (automatically)
Perform the following steps to print on both sides (automatically). To check for supported media for
2–sided printing, see
.
1.
Verify that the printer driver is configured for 2–sided printing. For instructions, see the online
help for the printer driver.
2.
Select the appropriate 2–sided printing options in the printer driver software, including page and
binding orientation.
NOTE
When using 2–sided printing, load pre-printed forms and letterhead into Tray 1 face-
up with the bottom edge of the page feeding first. Load preprinted forms and letterhead into
Tray 2 and Tray 3 face-down with the top edge at the back of the tray.
NOTE
Loading pre-printed forms and letterhead is different than loading for 1–sided printing.
96
Chapter 9 How do I?
ENWW