To check and order using hp web jetadmin, Storing supplies, Replacing and recycling supplies – HP 2605dtn User Manual
Page 141: Hp policy on non-hp supplies, Resetting the printer for non-hp supplies
To check and order using HP Web Jetadmin
In HP Web Jetadmin, select the printer. The device status page shows supplies information. To
order, use the HP ToolboxFX. Or, see
Accessories and ordering information
Storing supplies
Follow these guidelines for storing print cartridges:
●
Do not remove the print cartridge from its package until you are ready to use it.
CAUTION
To prevent damage, do not expose the print cartridge to light for more than a
few minutes.
●
See
Table C-4 Environmental specifications
for operating and storage temperature ranges.
●
Store the supply in a horizontal position.
●
Store the supply in a dark, dry location away from heat and magnetic sources.
Replacing and recycling supplies
To install a new HP print cartridge, follow the instructions that are included on the box that contains
the new supply, or see the Getting Started Guide.
To recycle supplies, place the used supply in the box in which the new supply arrived. Use the
enclosed return label to send the used supply to HP for recycling. For complete information, see the
recycling guide that is included with each new HP supply item. See
more information about HP's recycling program.
HP policy on non-HP supplies
Hewlett-Packard Company cannot recommend the use of non-HP supplies, either new or
remanufactured. Because they are not HP products, HP cannot influence their design or control their
quality. Service or repairs required as a result of using a non-HP supply will not be covered under the
printer warranty.
When you insert a supply into the printer, the printer will inform you if the supply is not a genuine HP
supply. If you insert a genuine HP supply that has reached the low state from another HP printer, the
printer identifies the supply as non-HP. Simply return the supply to the original printer to reactivate
HP features and functionality.
Resetting the printer for non-HP supplies
When you install a non-HP print cartridge, the light next to the print cartridge you replaced blinks and
the Attention light is on. In order to print with this supply, you must press (
Select
) the first time you
install this non-HP supply. The status gauges will not indicate when this type of supply is low or empty.
CAUTION
The printer will not stop printing when this type of supply is empty. Printer
damage could occur if the printer prints with an empty print cartridge. See
Print Cartridge Limited Warranty Statement
ENWW
Managing supplies
129