Automatic configuration, Link speed and duplex settings – HP 2605dtn User Manual
Page 94
9.
Press (
Left arrow
) or (
Right arrow
) to enter the next three digits of the IP address.
10.
Press (
Select
) to save those digits and move to the next three digits of the IP address.
11.
Press (
Left arrow
) or (
Right arrow
) to enter the next three digits of the IP address.
12.
Press (
Select
) to save those digits and move to the next three digits of the IP address.
13.
Press (
Left arrow
) or (
Right arrow
) to enter the next three digits of the IP address.
14.
Press (
Select
).
15.
The control panel will display Yes. Press (
Select
) to save the configuration, or to delete and
re-enter another IP address, press (
Left arrow
) or (
Right arrow
), which will change the
display to No.
16.
After selecting the IP address, you will be prompted to enter the subnet mask and default
gateway using steps 7-14 above.
17.
If at any time during the configuration you press
(
Cancel Job
), the system will exit the menu
and the addresses will not be saved.
Automatic configuration
1.
On the control panel menu, press (
Select
).
2.
Use the (
Left arrow
) or (
Right arrow
) button to select Network config., and then press
(
Select
).
3.
Use the (
Left arrow
) or (
Right arrow
) button to select TCPIP config, and then press
(
Select
).
4.
Use the (
Left arrow
) or (
Right arrow
) button to select Automatic, and then press
(
Select
).
It may take several minutes before the automatic IP address is ready for use.
NOTE
If you want to disable or enable specific automatic IP modes (such as BOOTP,
DHCP, or AutoIP), these settings can be changed by using the embedded Web server or
HP ToolboxFX only.
Link speed and duplex settings
NOTE
Incorrect changes to the link speed and duplex settings might prevent the printer from
communicating with other network devices. For most situations, the printer should be left in
automatic mode. Also note that changes will cause the printer to power cycle. Changes should
only be made while the printer is idle.
1.
On the control panel menu, press (
Select
).
2.
Use the (
Left arrow
) or (
Right arrow
) button to select Network config., and then press
(
Select
).
82
Chapter 8 Networking
ENWW