Husqvarna DXR-310 - Manual (Page 25)

STARTING AND STOPPING
Starting the electric motor
• The electric motor is started by pressing the start
button.
• If several machines are used at the same workplace
there is a risk of mixing up the remote controls.
Press the horn to see which machine is connected
to the remote control. The machine will beep
and fl ash three times. Do not activate the remote
control before you have ensured that the correct
machine is being operated.
Activating controls
• To activate the remote control’s operating func-
tions press the left button on the right joystick. The
remote control is now in work mode. The light emit-
ting diode on the remote control has a permanent
blue light.
• If no command is given within three seconds the
operating functions are locked. To return to work
mode, press the left button on the right joystick.
Stopping
• Manoeuvre the arm system down and allow it to
rest against the ground.
• Put all controls into neutral position.
• Press the stop button.
• Put the main switch into the OFF position (O).
Inspection after work
It can be benefi cial to carry out the daily inspection
after fi nishing work. Detecting damage in time can
prevent a shutdown on the following day.
Before starting
The following points should be checked when working
at a new site and every morning before starting:
• Carrying out daily inspections.
• Examine the machine for transport damage.
• Check that the machine’s safety features are intact.
Refer to ’The machine’s safety features” in the
’General working instructions” chapter.
• Check that the power cable and operating cables
are intact and correctly dimensioned.
• Check that the mains voltage is compatible with
the machine and that the correct fuses are used.
• Always connect the machine through an earth-fault
breaker with personal protection, i.e. an earth fault
circuit breaker that trips at an earth fault of 30 mA.
• Check that the emergency stop or machine stop
button are not pressed by turning them clockwise.
• Check that no tools or other objects have been left
lying on the machine.
Starting
Connect the machine
• Connect the machine to a 3 phase power supply.
• Turn on the main switch on the machine.
Starting the remote control
• Turn the switch to the ON position (I). In this posi-
tion the remote control is supplied with current.
The light emitting diode on the remote control
fl ashes rapidly with a blue light when it is searching
for contact. When it fl ashes with a longer interval
the machine is in standby mode.
• If a function is not working or needs attention, an
error message appears on the display in conjunc-
tion with start-up. Refer to ’Error messages” in the
’Trouble shooting” section.
English -
25