Husqvarna DXR-310 - Manual (Page 5)

Inspections and/or maintenance must be
carried out with the motor switched off
and the power cord disconnected.
Always connect the machine
through an earth-fault breaker with
personal protection, i.e. an earth
fault circuit breaker that trips at an
earth fault of 30 mA.
Ensure that the power cable can-
not be run over. Take particular care
when moving or when the outriggers
are being retracted or extended.
Risk of electric shock.
The lifting equipment must be attached at
all the machine’s lifting points.
Keep your distance! Nobody is
permitted to be within the machine’s
risk area when work is underway.
The machine’s risk area can vary
during the course of the work.
The machine can overturn during
work. During operation the machine
must be positioned as level as pos-
sible and the outriggers must be fully
extended.
This product is in accordance with ap-
plicable EC directives.
Symbols on the machine
WARNING! The machine can be danger-
ous if used incorrectly or carelessly, and
can cause serious or fatal injury to the
operator or others.
Please read the Operator’s Manual care-
fully and make sure you understand the
instructions before using the machine.
Noise emission to the environment ac-
cording to the European Community’s
Directive. The machine’s emission is
specifi ed in chapter Technical data and on
label.
Always wear:
• Tight-fi tting, heavy-duty and comfort-
able clothing that permit full freedom
of movement.
• Sturdy, non-slip boots or shoes.
• Protective gloves.
• Protective helmet.
• Hearing protection.
• Protective goggles or visor.
• A breathing mask, gas mask or fresh
air helmet must be used when work-
ing in environments where the air can
be harmful to health.
WARNING! High-voltage current.
WARNING! Ensure that no material can fall
down and cause damage when you are
using the machine.
WARNING! Watch out for demolition mate-
rial becoming loose when cutting. Use
personal safety equipment and keep your
distance.
WARNING! Always position yourself above
the machine when driving on a slope.
There is a risk of the machine tipping.
WARNING! Exercise particular caution
when working close to edges. Ensure that
the machine is stable and does not move
closer to the edge while the work is in
progress. Ensure that the underlying sur-
face has satisfactory bearing capacity.
KEY TO SYMBOLS
English -
5