Husqvarna DXR-310 - Manual (Page 26)

Key to commands
1. Right and left button on right joystick
2. Right and left button on left joystick
3. Direction joystick
4. Left and right joystick respectively
Designation of the
machine’s parts
1. Arm 1
2. Arm 2
3. Arm 3
4. Tool
5. Outrigger
6. Caterpillar tracks
7. Tower
OPERATION
Operating modes
The machine can be operated in three different
modes: transport mode, set-up mode and work mode.
All commands in each of the modes are described in
this section.
• Work mode - In this mode you can operate every-
thing except the caterpillar tracks and outriggers.
• Set-up mode - In this mode you can operate the
caterpillar tracks and outriggers.
• Transport mode - In this mode you can operate the
caterpillar tracks and some arm functions.
If no controls have been used for three seconds the
machine goes into idling mode. In this mode hydraulic
oil is pumped into the tank and there is no pressure in
the cylinders.
Option
External tools
External hydraulic tools can be connected to the ma-
chine. The mode is activated by pressing the button
for external tools. In this mode the machine cannot be
operated from the remote control.
Emergency operation
IMPORTANT!
To be driven in the emergency operation mode
the machine must be fi tted with hand levers.
Emergency operation is used in conjunction with
terminal or control system problems. The mode is
activated by putting the knob into the position for
emergency operation.
When emergency operation is activated the machine
turns off and has to be restarted using the start button
on the machine. In this mode the machine can only be
moved using emergency operation, other functions are
disconnected. When emergency operation is deacti-
vated the machine turns off and has to be restarted
using the remote control.
1 2
3
4
1
2
3
4
5
6
7
26
- English