Hitachi SH-G1000 - Manual (Page 34)

Section 2: Understanding Your Device
26 2A: Your PCS Phone – The Basics
Initialization
Perform initialization only when pushing the Reset button does not allow
the device to be restarted.
Note: Initialization will cause all data saved in the device’s memory to be
erased. The programs preinstalled before shipment will not be erased.
Before performing initialization, back up important data using a
personal computer or a memory card. For details about data backup, see
“Backing Up Data” on page 179.
Note: Remove a memory card before starting initialization.
1. Remove the AC adapter and peripheral equipment from the device.
Executing initialization with equipment connected may result in
initialization failure.
2. Remove the main battery. To remove, see “Removing the Main
Battery” on page 18.
3. Using a non-conductive fine tool, shift the Full Reset switch downward
(lock position). The power is switched off.
4. Wait for approximately two minutes.
5. Install the main battery. To install, see “Installing the Main Battery”
on page 16.
Lock Lock Lock
Full Reset switch Full Reset switch
Full Reset
Switch