Document Outline

• Declaration of Conformity
  • Compliance Information
• Contents
• About This Document
  • Who Should Use This Document
  • How This Document Is Organized
  • Contacts
    • Web Site
    • The Americas
    • Europe, Africa, Middle East, and India
    • Asia Pacific
  • Document Conventions
• Introduction
  • External View
  • Control Panel
    • Control Panel Buttons
    • Control Panel Lights
  • Printer Media Compartment
• Printer Setup
  • Before You Begin
  • Handling the Printer
    • Unpack and Inspect the Printer
    • Store the Printer
    • Ship the Printer
    • Recycle the Printer
  • Select a Site for the Printer
    • Select a Surface
    • Provide Proper Operating Conditions
    • Allow Proper Space
    • Provide a Data Source
    • Provide a Power Source
  • Connect the Printer to a Power Source
    • Power Cord Specifications
  • Select a Communication Interface
    • Connector Locations
    • Types of Connections
    • Data Cable Requirements
  • Types of Media
  • Ribbon Overview
    • When to Use Ribbon
    • Coated Side of Ribbon
• Operations
  • Media Loading Overview
    • Print Modes
    • Start a Roll of Media
    • Insert Media into the Printer
  • Load Media in Tear-Off Mode
  • Load Media in Peel-Off Mode or Liner Take-Up Mode
    • Remove Liner in Peel-Off with Liner Take-up Mode
  • Load Media in Cutter Mode
  • Load Media in Rewind Mode
    • Remove Printed Labels or Liner from the Rewind Spindle
    • Adjust Media Alignment for Rewind Option
  • Load Ribbon
    • Remove Used Ribbon
  • Calibrate the Printer
    • Auto Calibration
    • Manual Calibration
  • Position the Media Sensors
    • Select or Position the Transmissive Sensor
    • Adjust the Reflective Sensor
  • Adjust Printhead Pressure
  • Install Memory Card
• Configuration
  • Setup Mode
    • Enter Setup Mode
    • Exit Setup Mode
  • Change Password-Protected Parameters
    • Default Password Value
    • Disable the Password Protection Feature
  • Print a Configuration Label
  • Print a Network Configuration Label
  • Control Panel LCD Displays
    • Print Server LCD Displays
• Routine Maintenance
  • Lubrication
  • Cleaning Procedures
    • Clean the Exterior
    • Clean the Printhead and Platen Roller
    • Clean the Media Compartment and Sensors
    • Clean the Rewind Option
    • Clean the Peel-Off Assembly
    • Clean the Cutter Module
  • Fuse Replacement
• Troubleshooting
  • Troubleshooting Checklists
  • LCD Error Messages
  • Print Quality Problems
  • Calibration Problems
  • Communications Problems
  • Miscellaneous Printer Problems
  • Printer Diagnostics
    • Power-On Self Test
    • CANCEL Self Test
    • PAUSE Self Test
    • FEED Self Test
    • FEED and PAUSE Self Test
    • Communications Diagnostics Test
• Data Ports
  • Parallel Data Port
    • Parallel Cabling Requirements
    • Parallel Port Interconnections
  • Serial Data Port
    • Hardware Control Signal Descriptions
    • Pin Configuration
    • RS-232 Interface Connections
• Specifications
  • General Specifications
  • Agency Approvals
  • Printing Specifications
  • Media Specifications
  • Ribbon Specifications
  • Printer Options
  • ZPL II Features
  • Supported Bar Codes
• Index