Zebra Technologies Z4Mplus - Manual (Page 104)

Configuration
Control Panel LCD Displays 96
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Print Server LCD Displays
The menu options shown in Table 10 display only if you have a print server installed.
Table 10 • Print Server Parameters (Page 1 of 5)
Parameter Action/Explanation
Load LAN Source
1
This parameter, which serves the same function as the ^NP ZPL command,
specifies whether to use the printer’s or the print server’s IP settings at
bootup.
Default: PRINTER
Selections: PRINTER, PRINTSERVER
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
Check for Wired PrintServer
1
This parameter, which serves the same function as the ^NB ZPL command,
tells the printer whether to search for a wired print server at bootup.
Default: NO
Selections: YES, NO
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
LOAD LAN FROM?
PRINTER
WIRED PS CHECK?
NO