Zebra Technologies Z4Mplus User Manual
Page 70
Advertising
Operations
Position the Media Sensors
62
13163L-001 Rev. A
Z4Mplus/Z6Mplus User Guide
1/18/06
To adjust the reflective sensor, complete these steps:
1.
. Press the printhead release latch.
2.
Lift the printhead until it latches open.
3.
Locate the reflective sensor positioning lever.
4.
Move the reflective sensor positioning lever across the width of the media until the
reflective sensor aligns with the gap or notch.
5.
Close the printhead assembly.
Advertising