Zebra Technologies Z4Mplus - Manual (Page 89)

81 Configuration
Control Panel LCD Displays
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
Format Memory Card
This option erases all previously stored information from the optional
PCMCIA card or Compact Flash card.
Caution • This option completely erases the selected card.
To format a memory card:
1. Press SELECT to select the parameter.
2. Press MINUS (-) to select
A:
or PLUS (+) to select
B:
.
If your printer is set to require a password, you are prompted to enter
the password.
3. Enter the password. For instructions, see Change Password-Protected
Parameters on page 70 .
4. Press the appropriate button again to select the desired card.
The display shows ARE YOU SURE? .
5. Do you wish to continue?
• Press MINUS (-) to select
NO
to cancel the request and return to
FORMAT CARD prompt.
• Press PLUS (+) to select YES and begin initialization.
When initialization is complete, the printer automatically exits Setup
mode, and the control panel displays
PRINTER READY . If you exit
Setup mode while initialization is still in process, the control panel
display flashes between the phrases
CHECKING B: MEMORY and
PRINTER IDLE
.
Note • Depending on the amount of memory in the memory card,
initialization may take up to 5 minutes to complete.
6. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 9 of 23)
Parameter Action/Explanation
FORMAT CARD:
A: B: