Zebra Technologies Z4Mplus - Manual (Page 94)

Configuration
Control Panel LCD Displays 86
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Set Data Bits
The data bits of the printer must match the data bits of the host computer
for accurate communications to take place. Set the data bits to match the
setting being used by the host computer.
Note • Code Page 850 requires the data bits to be set to 8 bits. See
the ZPL II Programming Guide for more information.
Default: 8 BITS
Selections: 7 BITS, 8 BITS
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
Set Parity
The parity of the printer must match the parity of the host computer for
accurate communications to take place. Select the parity that matches the
one being used by the host computer.
Default: NONE
Selections: EVEN, ODD, NONE
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Set Host Handshake
The handshake protocol of the printer must match the handshake protocol
of the host computer for communication to take place. Select the handshake
protocol that matches the one being used by the host computer.
Default: XON/XOFF
Selections: XON/XOFF, DTR/DSR, RTS/CTS
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 14 of 23)
Parameter Action/Explanation
DATA BITS
- 8 BITS
PARITY
- NONE +
HOST HANDSHAKE
- XON/XOFF +