Zebra Technologies Z4Mplus - Manual (Page 108)

Configuration
Control Panel LCD Displays 100
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Reset Network
2,3
This option resets the wireless card and the print server when the wireless
option is running. Selecting this option has no effect when the wireless
option is not running, when there is no card inserted, or when the wireless
password is anything other than the default (zero).
1. Press SELECT to select the parameter.
2. Press PLUS (+) to select YES .
The LCD prompts ARE YOU SURE? .
• Press MINUS (–) to select NO and cancel the request.
• Press PLUS (+) to select
YES
and reset the network.
3. Press SELECT to accept any changes and deselect the parameter.
Table 10 • Print Server Parameters (Page 5 of 5)
Parameter Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
RESET NETWORK
YES