Zebra Technologies Z4Mplus - Manual (Page 85)

77 Configuration
Control Panel LCD Displays
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
Set Print Width
Determines the printable area across the width of the label given the
resolution of the printer.
Default: 104 0/8 MM
Note • Setting the width too narrow can result in portions of the
label not being printed on the media. Setting the width too wide
wastes formatting memory and can cause printing off the label and
on the platen roller. This setting can affect the horizontal position of
the label format if the image was inverted using the ^POI ZPL II
command.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (-) to move the cursor.
3. Press PLUS (+) to increase the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
To change the unit of measurement:
1. Press SELECT to select the parameter.
2. Press MINUS (-) until the unit of measurement is active.
3. Press PLUS (+) to toggle to a different unit of measure (mm, inches,
or dots).
4. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 5 of 23)
Parameter Action/Explanation
PRINT WIDTH
- 104 0/8 MM +