Zebra Technologies Z4Mplus - Manual (Page 41)

33 Operations
Load Media in Tear-Off Mode
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
5. Feed the media under the dancer assembly (
1
), through the slot in the transmissive
sensor (
2
—standard transmissive sensor shown), and under the ribbon sensor (
3
).
6. Push the media to the back of the transmissive sensor (
1
). Slide in the media guide (
2
)
until it just touches the edge of the media.
7. Close the printhead assembly.
8. If the printer is paused (the Pause light is blinking), press PAUSE to enable printing.
1 2 3
1
2