Zebra Technologies Z4Mplus - Manual (Page 102)

Configuration
Control Panel LCD Displays 94
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Select Idle Display
This parameter selects the LCD options for the real-time clock.
Note • If the default value is not selected, pressing PLUS (+) or
MINUS (-) briefly displays the firmware version of the printer.
Default: FIRMWARE VERSION
Selections: MM/DD/YY (24 HOUR), MM/DD/YY (12 HOUR),
DD/MM/YY (24 HOUR), DD/MM/YY (12 HOUR), FW VERSION
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Set RTC Date
This parameter allows you to set the date following the convention selected
in
IDLE DISPLAY .
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (-) to move to the next digit position.
3. Press PLUS (+) to change the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
Set RTC Time
This parameter allows you to set the time following the convention selected
in
IDLE DISPLAY .
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (-) to move to the next digit position.
3. Press PLUS (+) to change the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
Specify Password Level
This parameter allows you to select whether certain factory-selected menu
items or all menu items are password protected.
Default: SELECTED ITEMS
Selections: SELECTED ITEMS, ALL ITEMS
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 22 of 23)
Parameter Action/Explanation
IDLE DISPLAY
- FW VERSION +
RTC DATE
- 01/31/01 +
RTC TIME
- 14:55 +
PASSWORD LEVEL
- SELECTED ITEMS +