Zebra Technologies Z4Mplus - Manual (Page 68)

Operations
Position the Media Sensors 60
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Figure 23 • Transmissive Sensor with Adjustment Tab Pointer
To adjust the transmissive sensor, complete these steps:
1. Press the printhead open lever to release the printhead assembly.
2. See Figure 22 . Locate the transmissive sensor.
3. Locate the white adjustment tab pointer on the back of the transmissive sensor.
4. What type of media are you using?
5. Ensure the media and ribbon are properly positioned.
6. Close the printhead assembly.
1
2
1
3
1
Positioning marks
2
Adjustment tab pointer (outer position)
3
Adjustment tab pointer (inner position)
If you are using… Then…
Non-continuous media
with notched edges Move the adjustment tab pointer to the inner positioning
mark. The point of the tab should align with the mark.
Non-continuous media
without notched edges Move the adjustment tab to the outer positioning mark. The
point of the tab should align with the mark.
Continuous media Move the adjustment tab to the outer positioning mark. The
point of the tab should align with the mark.