Zebra Technologies Z4Mplus User Manual
Page 106
Configuration
Control Panel LCD Displays
98
13163L-001 Rev. A
Z4Mplus/Z6Mplus User Guide
1/18/06
Specify Default Gateway
2
This parameter allows you to select the IP address that the network traffic is
routed through if the destination address is not part of the local network.
To change the value shown:
1.
Press
SELECT
to select the parameter.
2.
Press
MINUS (–)
to move the cursor.
3.
Press
PLUS (+)
to increase the value of the digit.
4.
Press
SELECT
to accept any changes and deselect the parameter.
View MAC Address
1,3
Displays the MAC address of the wireless card. This parameter cannot be
changed through the control panel.
View ESSID
1,3
This parameter cannot be changed through the control panel. Use the
^WS
ZPL command to change the value. For more information, see the Wireless
Print Server User Guide.
Select Authentication Type
1,3
If encryption is on, specify whether to use open or shared authentication.
Default: OPEN
Selections: OPEN, SHARED
To change the value shown:
1.
Press
SELECT
to select the parameter.
2.
Press
PLUS (+)
or
MINUS (–)
to toggle between the options.
3.
Press
SELECT
to accept any changes and deselect the parameter.
Enable LEAP Mode
3,4
LEAP is an encryption method that is available with some wireless cards.
Set the LEAP user name and password through the printer web pages.
Default: OFF
Selections: ON, OFF
To change the value shown:
1.
Press
SELECT
to select the parameter.
2.
Press
PLUS (+)
or
MINUS (–)
to toggle between the options.
3.
Press
SELECT
to accept any changes and deselect the parameter.
Table 10 • Print Server Parameters (Page 3 of 5)
Parameter
Action/Explanation
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
DEFAULT GATEWAY
000.000.000.000
MAC ADDRESS
000000000000
ESSID
125
AUTH. TYPE
OPEN
LEAP MODE
OFF