Zebra Technologies Z4Mplus - Manual (Page 30)

Printer Setup
Select a Communication Interface 22
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Data Cable Requirements
Data cables must be fully shielded and fitted with metal or metallized connector shells.
Shielded cables and connectors are required to prevent radiation and reception of electrical
noise.
To minimize electrical noise pickup in the cable:
• Keep data cables as short as possible.
• Do not bundle the data cables tightly with the power cords.
• Do not tie the data cables to power wire conduits.
Note • Zebra printers comply with FCC Rules and Regulations, Part 15 for Class B
Equipment using fully shielded, 6.5 ft. (2 m) data cables. Use of unshielded cables may
increase radiation above the Class B limits.