Zebra Technologies Z4Mplus - Manual (Page 82)

Configuration
Control Panel LCD Displays 74
13163L-001 Rev. A Z4Mplus/Z6Mplus User Guide 1/18/06
Adjust Print Speed
Adjusts the speed for printing a label (given in inches per second). Slower
print speeds typically yield better print quality. Print speed changes take
effect upon exiting Setup mode.
Default: 2 IPS
Range: 2 to 10 IPS
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value.
3. Press MINUS (-) to decrease the value.
4. Press SELECT to accept any changes and deselect the parameter.
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing.
See Figure 29 . Higher numbers move the media out (the tear line moves
closer to the leading edge of the next label), and lower numbers move the
media in (the tear line moves closer to the edge of the label just printed).
Figure 29 • Tear-Off Position Adjustment
Default: +0
Range: –120 to +120
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value. Each press adjusts the tear-off
position by four dot rows.
3. Press MINUS (-) to decrease the value. Each press adjusts the tear-off
position by four dot rows.
4. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters (Page 2 of 23)
Parameter Action/Explanation
PRINT SPEED
2 IPS +
TEAR OFF +000
- +
1
Media direction
2
Factory-set tear line location at position 00
1
2