Hearth and Home Technologies ESCAPE-42DV - Manual (Page 36)

Heat & Glo • Escape-42DV • 2052-900 Rev. R • 10/08 36
E. Positioning the Logs Log Assembly: LOGS-Escape-42
If the gas logs have been factory
installed they should not need to
be positioned. If the logs have been
packaged separately, refer to the
following instructions.
NOTE: If sooting occurs, the logs
may need to be repositioned slightly
to avoid excessive fl ame impinge-
ment.
Step 1.
Note: If bulb and orange lens are al-
ready installed, proceed to Step 2.
Remove the bulb from its packag-
ing and locate the sockets installed
in the square cut outs in the fi rebox
fl oor. The bulbs contacts push into
the two small holes in the socket
top, as shown.
Place the framed orange lens on
top of the fi rebox fl oor covering the
bulb as shown. The four tabs on
the lens frame go into the square
cut out to help locate the lens.
CAUTION: Logs are fragile!
Carefully remove the logs from the
packaging.
Figure 12.1
Figure 12.2
Figure 12.3
2052-925B
1 1
1 1
1 1
7 7
6 6
3 3
4 4
8 8
2 2
2 2
5 5