Frymaster KSCF18G - Manual (Page 8)

KSCF18G COOL ZONE SERIES GAS FRYERS
CHAPTER 2: IMPORTANT INFORMATION
2-1
2.1 Receiving and Unpacking Equipment
A. Check that the container is upright. Use an outward prying motion - no hammering - to
remove the carton. Unpack the fryer carefully and remove all accessories from the carton.
Do not discard or misplace these, as they will be needed.
B. After unpacking, immediately check the equipment for visible signs of shipping damage. If
damage has occurred, contact the carrier and file the appropriate freight claims. Do not
contact the factory. Shipping damage responsibility is between the carrier and the dealer.
If your equipment arrives damaged:
1. File claim for damages immediately, regardless of extent of damage.
2. Visible loss or damage: Be sure this is noted on the freight bill or express receipt and is
signed by the person making the delivery.
3. Concealed loss or damage: If damage is unnoticed until equipment is unpacked, notify
freight company or carrier immediately, and file a concealed damage claim. This should
be done within fifteen (15) days of date of delivery. Be sure to retain container for
inspection.
NOTE: Frymaster does not assume responsibility for damage or loss incurred in transit.
C. Frying systems with built-in filtration: Take off the filter support brace and remove the
filter pan from the cabinet.
D. Remove all plastic skin from sides, front, and doors of the fryer(s). Failure to do this prior to
initial fryer operation will make it very difficult to remove later.
2.2 General
Upon arrival, inspect the fryer carefully for visible or concealed damage. (See Receiving and
Unpacking Equipment, Section 2.1.)
The Frymaster KSCF18G Cool Zone Series Fryers are energy-efficient, gas-fired units, design-
certified by the International Approval Services (AGA/CGA), Gaz de France, and NSF International
and manufactured to their basic performance and application specifications.
All units are shipped completely assembled with accessories packed inside the frypots. All units are
adjusted, tested, and inspected at the factory before shipment. Sizes, weights, and input rates of all
models are listed in this manual.